I have a Rouge, and this error showed up, for a few minutes. After shutting down and starting up a few minutes later the error disappeared, luckily none of the issues mentioned before me. However i did look it up in the manual, here is what it said; Chassis Control System Error: See Owners Manual (Section 8) (if so equipped) This warning appears if the Integrated Dynamics-control Module detects an error in the Intelligent Trace Control, Intelligent Engine Brake, or the Active Ride Control systems. Have the system checked. It is recommended that you visit a NISSAN dealer for this service. For additional information, refer to Chassis control in the Starting and driving section 5 of this manual. CHASSIS CONTROL (Section 5-157 to 5-159) The chassis control is an electric control module that includes the following functions: Intelligent Trace Control Intelligent Engine Brake Active Ride Control INTELLIGENT TRACE CONTROL (I-TC) This system senses driving based on the drivers steering and acceleration/braking patterns, and controls brake pressure at individual wheels to aid tracing at corners and help smooth vehicle response. The I-TC can be set to on (enabled) or off (disabled) through the vehicle information display Settings page. For additional information, refer to Vehicle information dis- play in the Instruments and controls section of this manual. When the Vehicle Dynamic Control (VDC) OFF switch is used to turn off the VDC system, the I-TC is also turned off. When the I-TC is operated and the Chassis Control mode is selected in the vehicle in- formation display, the I-TC graphics are shown in the vehicle information display. For additional information, refer to Vehicle information display in the Instruments and controls section of this manual. If the Chassis Control System Error: See Owners Manual warning message appears in the vehicle information display, it may indicate that the I-TC is not function- ing properly. Have the system checked as soon as possible. It is recommended that you visit a NISSAN dealer for this service. LSD When the I-TC is operating, you may feel a pulsation in the brake pedal and hear a noise. This is normal and indicates that the I-TC is operating properly. Even if the I-TC is turned off, some functions will remain on to assist the driver (for ex- ample, avoidance scenes). WARNING The I-TC may not be effective depending on the driving condition. Always drive carefully and attentively. Starting and driving 5-157 INTELLIGENT ENGINE BRAKE (I-EB) The I-EB function adds subtle deceleration by controlling Continuously Variable Trans- mission (CVT) gear ratio, depending on the cornering condition calculated from drivers steering input and plural sensors. This benefit is for easier traceability and less workload of adjusting speed with braking at corners. The I-EB also enhances braking feel by adding subtle deceleration with CVT gear ratio control according to drivers brake pedal operation The I-EB can be set to on (enabled) or off (disabled) through the vehicle information display Settings page. For additional information, refer to Vehicle information dis- play in the Instruments and controls section of this manual. When the I-EB is operated at corners and the Chassis Control mode is selected in the vehicle information display, the I-EB graphics are shown in the vehicle information display. For additional information, refer to Vehicle information display in the Instruments and controls section of this manual. If the Chassis Control System Error: See Owners Manual warning message appears in the vehicle information display, it may indicate that the I-EB is not function- ing properly. Have the system checked as soon as possible. It is recommended that you visit a NISSAN dealer for this service. LSD When the I-EB is operating, the needle of the tachometer will rise up and you may hear an engine noise. This is normal and indicates that the I-EB is operating properly. ACTIVE RIDE CONTROL (ARC) This system senses upper body motion (based on wheel speed information) and controls engine torque and four wheel brake pressure. This will enhance ride com- fort in effort to restrain uncomfortable up- per body movement when passing over undulated road surfaces. This system comes into effect above 25 mph (40 km/h). When the Vehicle Dynamic Control (VDC) OFF switch is used to turn off the VDC system, the ARC is also turned off. When the ARC is operating, you may hear noise and sense slight deceleration. This is normal and indicates that the ARC is operating properly. LSD When brake control of ARC is operated and the Chassis Control mode is selected in the vehicle information display, the ARC graphics are shown in the vehicle information display. For additional information, refer to Vehicle information display in the Instruments and controls section of this manual. If the Chassis Control System Error: See Owners Manual warning message appears in the vehicle information display, it may indicate that the ARC is not function- ing properly. Have the system checked as soon as possible. It is recommended that you visit a NISSAN dealer for this service.
Goto huaneng to know more.
2 people found this helpful.
Want more information on active ride control nissan? Feel free to contact us.
Owning or leasing a Nissan Kicks goes well beyond alluring style and premium interior amenities and focuses also on class-leading safety. To prove this point, spend a few minutes looking over the bevy of outstanding safety features found in a new Nissan Kicks from Dick Smith Nissan of Columbia, which include:
The moral of the story here? By leveraging enticing style, luxury amenities, and class-leading safety features, the Nissan Kicks now for sale or lease here at Dick Smith Nissan of Columbia has cemented itself as the purveyor of the finest driving experience in Columbia.
For more adss pole attachment hardwareinformation, please contact us. We will provide professional answers.